Télécharger Imprimer la page

Echo DLM-310/46P Manuel Opérateur page 12

Publicité

10.3 STORE THE MACHINE
Remove the safety key.
Remove the battery pack(s).
Clean the machine before storage.
Make sure the motor is not hot when you store the
machine.
Make sure that the machine does not have loose
or damaged parts. If it is necessary, follow these
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to your dealer.
Store the machine in a dry area.
Make sure that children cannot come near the
machine.
10.4 STAND THE MACHINE ON END
Figure 11.
WARNING
It is necessary to remove the safety key and the
battery pack before putting the mower in vertical
storage.
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the
brackets touch the floor.
6. Put the grass bag on the inside of the deck and hide
the blade during the storage position to reduce the
risk of injury from touching the blade.
11
TROUBLESHOOTING
Problem
Possible cause
The handle is
The bolts are not
not in position.
engaged correct-
ly.
The machine
The battery ca-
does not start.
pacity is low.
The handle
switch is defec-
tive.
The safety key is
not put in.
English Original Instructions
Solution
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the han-
dle switch.
Put in the safety
key.
11
Problem
Possible cause
The machine
The lawn is
cuts grass un-
rough.
evenly.
The blade height
is not set cor-
rectly.
The machine
Wet grass clip-
does not mulch
pings attach to
correctly.
the deck.
The mulch plug
is missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high
The blade is un-
vibration in the
balanced and
machine.
worn.
The motor shaft
is bent.
The machine
The blade height
stops during
is too low.
mowing.
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.
* If you cannot find the solution to these problems,
contact your dealer.
12
TECHNICAL DATA
Rated voltage
36 V DC, 40 V max
EN
Solution
Examine the
mowing area.
Adjust the blade/
cutting height to
a higher position.
Wait until the
grass dries be-
fore mowing.
Install the mulch
plug.
Increase the
blade/cutting
height.
Empty the grass
clippings from
the grass catch-
er.
Replace the
blade.
1. Stop the mo-
tor.
2. Remove the
safety key
and battery
pack.
3. Inspect for
damage.
4. Contact your
dealer to re-
pair it.
Increase the
blade/cutting
height.
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.

Publicité

loading