Publicité
TROUBLESHOOTING
Caution!
Only a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
Important!
refrigerant circulation).
Problem
Appliance does not
work
Appliance freezes
or cools too much
The food is not
frozen enough.
Heavy build up of
frost on the door
seal.
Unusual noises
Indicate lights flashing
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the
necessary data here, refer to the rating plate.
EN
Before troubleshooting, disconnect the power supply.
There are some sounds during normal use (compressor,
Possible cause
Mains plug is not plugged in
or is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold。
Temperature is not
properly adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air tight.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Sensor fault
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a cool
setting). At the same time shape the
warmed door seal by hand such that it
sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Inform the maintenance center
23
Solution
Publicité
