Motion Control; Using The Memory - visomat soft and smart comfort 20 Mode D'emploi

C
The symbol is stored with the respective measurement.
A more frequent appearance of the symbol may indicate cardiac
arrhythmia and must be discussed with your doctor! Measure-
ment results accompanied by irregular pulses should therefore
be viewed as critical and repeated under more favourable con-
ditions.

14. Motion control

Movements during the measurement may re-
sult in incorrect measurement values. The mo-
tion control registers stronger movements and
these are indicated by the symbol in the dis-
play. Other disruptive factors such as speaking,
coughing or cuff noises can cause the symbol to
be displayed. If this symbol appears, please re-
peat the measurement and avoid the disruptive factors.
The symbol is stored with the respective measurement.

15. Using the memory

The device stores the measured values in two memories (one per
user). Each memory can store up to 120 readings and the aver-
age value (A). The average value is calculated from the last three
measurements taken.
The measured results are automatically saved in the memory. If
more than 120 measured values are saved, the oldest measured
value (no. 120) is deleted so that the latest value (no. 1) can be
recorded.
EN-52
Operating the device Operating the device
Data retrieval
Set the user whose data you wish to retrieve.
To retrieve data, press the Memory button of
the user you wish to retrieve the data for while
the device is switched off. The average value is
displayed with "A" (Figure 1).
Press the Memory button again to display the most recently
measured values (Figure 2). If the date/time function is activated,
the memory number (Figure 2), the date (Figure 3) and the time
(Figure 4) are displayed alternately.
Press the Memory button repeatedly to recall further measured
values.
Figure 2 Figure 3
You can switch between the two memories by pressing Memory
button 1 or 2.
The stored data remain visible in the display for around 30 sec-
onds. The device then switches itself off.
Deleting data
To delete individual measured values, recall the
measured value you wish to delete.
Press the Memory button again and hold down
until the display firstly flashes and is then re-
placed with dashes.
C
Figure 1
Figure 4
EN-53