Publicité
► Fig.6: 1. Speed change lever
Displayed
Speed
Number
1
Low
2
High
To change the speed, switch off the tool first. Push the
speed change lever to display "2" for high speed or "1"
for low speed. Be sure that the speed change lever is
set to the correct position before operation.
If the tool speed is coming down extremely during the
operation with display "2", push the lever to display "1"
and restart the operation.
Adjusting ring
You can select the action mode and adjust the fastening
torque with the adjusting ring.
Adjusting the fastening torque
► Fig.8: 1. Adjusting ring 2. Mark (1 - 21 graduation) 3. Arrow
The fastening torque can be adjusted in 21 levels by turning the adjusting ring. Align the graduations with the arrow
on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 21.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
torque level is required for a particular application.
Graduation
1
Machine screw
M4
Wood
Soft
screw
wood
(e.g.
pine)
Hard
wood
(e.g.
lauan)
NOTE: The adjusting ring does not lock when the arrow is positioned only halfway between the graduations.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing side grip (auxiliary handle)
► Fig.9: 1. Side grip 2. Protrusion 3. Groove 4. Arm
Always use the side grip to ensure operating safety.
Install the side grip so that the protrusions on the arm fit
in the grooves on the tool barrel. Turn the grip clockwise
to secure it. The grip can be fixed at desired angle.
Installing or removing driver bit/
drill bit
► Fig.10: 1. Sleeve 2. Close 3. Open
Torque
Applicable
operation
High
Heavy load-
ing operation
Low
Light loading
operation
2
3
4
5
6
M5
–
ø3.5 x 22
–
ø3.5 x 22
Selecting the action mode
► Fig.7: 1. Adjusting ring 2. Mark 3. Arrow
This tool has two action modes.
1 - 21
Select the mode suitable for your work. Turn the adjust-
ing ring and align the mark that you select with the
arrow on the tool body.
NOTICE:
desired mode mark. If you operate the tool with the
ring positioned halfway between the mode marks, the
tool may be damaged.
NOTICE:
is rotating.
NOTICE:
switch on and run the tool for a second, then stop
the tool and slide the adjusting ring to your desired
position again.
7
8
9
10
11
12
M6
ø4.1 x 38
–
ø4.1 x 38
Turn the sleeve counterclockwise to open the chuck
jaws. Place the driver bit/drill bit in the chuck as far
as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
Installing hook
WARNING:
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
hook as too much force or irregular overburden
may cause damages to the tool resulting in per-
sonal injury.
8 ENGLISH
Drilling mode (rotation only)
Screwdriving mode (rotation
with clutch)
Always set the ring correctly to your
Do not change the action mode while tool
If it is difficult to slide the adjusting ring,
13
14
15
16
17
–
ø5.1 x 50
–
ø5.1 x 50
Use the hanging/mounting parts
Be careful not to overload the
18
19
20
21
–
–
Publicité
