Publicité
the thermostat to the application, you can finish the installation
and start using your thermostat, following the instructions in the
"offline user manual".
To connect the thermostat to your WiFi and use it with the
application, simply plug in the control panel, follow the steps in
"Connect the thermostat to the control panel", and then perform
the "WiFi installation".
Wireless installation
To use the thermostat wirelessly, the control panel must be the
one that activates and deactivates the boiler, therefore, we will
have to connect it directly to the boiler contacts.
Warning: This installation mode requires access to the boiler's
electrical connections, and must be carried out by specialized
personnel, making sure to disconnect the electrical current before
handling the boiler.
In the boiler diagram, locate the room thermostat connection, this
connection has two terminals, connect the supplied cable to these
terminals and close the boiler.
Connect the other end of the cable connected to the boiler, to the
COM and NO terminals, it does not matter which terminal you
connect each one to, if once the installation is finished, you check
that the boiler works in reverse, (it turns on when the temperature
drops and turns off when raising it), change the cable connected
to NO, to the NC terminal.
Note: If you have questions about the installation, contact our
technical service.
34
Publicité
