Publicité
4
5
6
3
4
00̲CHU304̲All.indb Eng-10
00̲CHU304̲All.indb Eng-10
Pull the end of the cuff outwards so
that the cuff is snug around your arm
and then secure the end to the hook-
and-loop fastener.
Place your arm on a table or the like,
so that the center of the cuff comes to
the height of your heart.
Relax your arm and lightly open your hand, with the palm upward.
Place the cuff at the height of the heart.
Press the "
START/STOP" switch.
• A beep is heard and all digits displayed is an initial display, indicating that the
monitor is functioning normal.
• The cuff is pressurized automatically.
* If the unit judges that pressurization is insufficient, it automatically repressurizes.
* The unit automatically sets the pressure based on the previous measurement.
*
is displayed when a pulse is detected.
* When you want to stop measurement, press the "
The cuff is deflated and measurement stops.
* If the previous user had a high pressure setting, that high pressure will
automatically be used for the current measurement.
* If the pressurization value exceeds 260 mmHg, if pressurization feels
abnormal, or if you want to stop the measurement process, press the
"
START/STOP" switch again. The cuff deflates, and the power turns off.
* Carefully place the cuff on your
arm, taking care to use the correct
tightness. The tightness is correct
if you can readily slide a finger
between the cuff and your arm.
- Eng 10 -
START/STOP" switch.
2015/01/15 14:53:22
2015/01/15 14:53:22
Publicité
