Operating Instructions; Lighting The Pilot Flame (Fig. 9); Total Extinguishing; Oven Burner (Fig. 10) - Bartscher 200.655 Mode D'emploi

The pilot light "S" lights, indicating that power is supplied to the appliance.
Turn the thermostat "U" to the required temperature.
The pilot light "T" lights, indicating that the resistors are on; as soon as the required
temperature is reached it goes out. When the resistors are newly actuated it lights again.
In order to switch off the appliance turn the knobs to the initial setting.

7. OPERATING INSTRUCTIONS

Caution: before using the appliance the plate has to be cleaned with hot water and detergent.
The appliance has to be used by qualified staff, since it is an appliance intended solely for professional kitchens. It also has to be
used under supervision and only for grilling food.

7.1 Lighting the pilot flame (Fig. 9)

Press on the knob "G" and turn it to the left as far as the pilot flame lighting position.
Keep the knob pressed and at the same time press button "H" for piezoelectric lighting. After
having lit the pilot flame keep the knob fully pressed for approximately 10/20 seconds in
order to heat the thermocouple, after which release it.
The flame can be observed from the spy hole on the front panel. Should the flame go out
during or after release of the knob repeat the operation.
7.2 Turning out the main burner
Turn the knob to the pilot flame position: the main burner goes out and only the pilot flame remains lit.

7.3 Total extinguishing

In order to extinguish the pilot flame and the main burner, turn the knob to the "off" position (Fig. 6).

7.4 Oven burner (Fig. 10)

7.4.1 Lighting the pilot flame

Turn the knob of the thermostat right as far as the stop. Press the lighting button "L" and at the same time press the button "N"
for piezoelectric lighting several times. Keep the lighting button fully pressed for a few moments in order to allow the
thermocouple to heat, then release it. The pilot flame can be observed through the appropriate spyhole. If, after having
released the lighting button, the pilot flame were to go out, the operation has to be repeated.

7.4.2 Lighting the main burner and regulating the temperature

With the pilot flame lit, turn the knob of the thermostat "M" left and select the required
cooking temperature.
Regulating the thermostat entails automatic lighting and turning out of the main burner
(on-off regulation, there is not minimum). If the thermostat knob is turned right as far as
the stop, the main burner goes out and only the pilot flame remains lit.

7.4.3 Turning out the oven

In order to turn out the pilot flame and also prevent lighting of the main burner, press the off button "O" down. The safety
device installed prevents relighting of the appliance for a few seconds.

8. MAINTENANCE

We recommend signing a maintenance contract at last once a year.
Clean the cooking plate after use with an emery cloth or with steel wool. After cleaning a thin layer of cooking oil has to be
applied to the plate surface in order to preserve it better.
The parts in stainless steel have to be cleaned gently, using warm water. If you use soap or detergent, make sure that they do
not contain abrasive products and that they are recommended for cleaning stainless steel.
If the appliance is not used for a certain period of time, close the gas supply cock. In the case of a fault in the appliance or
malfunctioning close the main gas inlet cock and call the technical service centre.
All repairs and fault remedying must be carried out by a skilled installer.
(Fig. 8)
300
270
240
210
170 100
130