Publicité
●
Before connecting your device to a power supply, allow it to stand upright for about 2 hours. This
reduces the risk of malfunction of the refrigeration system due to handling during transport.
●
Clean the inner surfaces of the unit with a soft cloth and warm water.
●
Leave 10cm of free space between the back and sides of the unit to allow for ventilation of the cooling
system. Failure to do so will result in poor cooling performance, dust build up on the components and
dramatically shorten the life of the product. It may also void the warranty.
Below are the guidelines for creating proper ventilation
Ventilation basics: While the unit is cooling(removing the heat)from its interior, the removed heat
is being dissipated through the condenser coil at the rear of appliance. This heat must be removed
with proper air circulation and exhausted to the outside of the cabinet enclosure. If this is not done,
excessive heat will build up inside the cabinet enclosure and prevent the unit from maintaining
proper cooling, increase power consumption and overheat the electrical components.
●
Place your unit on a floor strong enough to support the weight of the fully filled unit.
●
Make sure the unit is level by adjusting the front feet underneath the unit. Make sure that the
appliance rests on its feet in a stable manner.
●
Install the appliance away from direct sunlight and heat sources (radiator, hot plate, etc.). Direct
sunlight can damage the unit's coating and heat can increase its power consumption. If the ambient
temperature is extremely cold or hot, this may prevent the unit from operating properly.
●
The unit is not designed to be installed in a basement or cooler.
●
This unit is designed exclusively for indoor use.
Caution: Make sure that the unit is kept away from any substance that may cause combustion.
● Check that the water tank is in place before connecting the unit.
Publicité
