Publicité
Lever nut
(2)Loosen
Cam plate
(3) Pull
Remove the dies from the diehead.(4)
Terrajas
Replacing the dies
Insert each die into its corresponding slot number in
the die head as far as the line marked on the die.(1)
Turn the cam plate in the direction of the die-set (2)
and tighten the lever nut on the appropriate pipe size
position.(3)
Next push the cam plate upwards in the direction of
the die-set and set in position.(4)
3
Dies
(1)
Auto-open
lever A
Cam plate
(1)Push
Fig. 6
Replacing the dies
1. Open both chucks wider than the size of the pipe to
2. Close the rear chuck and, holding the pipe in your
Sacar
3. Next push the cam plate upwards in the direction of
Fig. 7
Pipe
4
Insert
Hints for short-pipes
Slot numberde
Setting a short pipe (which does not reach the rear
ranura
chuck).
With the hammer chuck slightly loose, move the pipe
into contact with the dies as shown in the diagram.
This will help hold the pipe on center while the
hammer chuck is tightened. In this way a smooth
taper cut is ensured every time.
Fig. 8
31
Getting ready
Lever nut
(3)Tighten
(2)Push
be cut and insert the pipe from the rear chuck side
where possible.
right hand, close the hammer chuck to grip the
pipe. Jerk the hand-wheel sharply towards you to
lock.
the die-set and set in position.(4)
Rear chuck
close
close
GB
(4)Push
Fig. 9
Fig. 10
Hammer chuck
Fig. 11
Publicité
