Publicité
The functionality of the equalizer bands 1 and 10 can be set either as fully parametric or as low-shelf
(band 1, LS) or hi-shelf (volume 10, HS).
EQ
NO FREQ
Q
1
30 – 20000 0.1 – 10.0 / LS -20 – +10
2
30 – 20000 0.1 – 10.0
3
30 – 20000 0.1 – 10.0
4
30 – 20000 0.1 – 10.0
5
30 – 20000 0.1 – 10.0
To set the frequency in Hertz under FREQ, the Q-factor or the functionality of bands 1 and 10 under Q and
the gain in dB under GAIN select the corresponding column in the desired equalizer band (NR 1 – 10),
confirm, set the value as desired and confirm again. The selected value is displayed in white.
The EQ bands can be disabled individually by selecting and confirming the band number. Instead of a
check mark icon, an X is now displayed and the values in the corresponding volume appear grayed out.
To activate the tape, select and confirm again.
The entire equalizer can be disabled by selecting the EQ line confirming, then selecting OFF and
confirming again. All values in the equalizer are now grayed out. To activate the equalizer, select ON
and confirm. To exit the menu level, select the arrow icon and confirm the selection.
DELAY
To delay the audio signal, select DELAY confirm, then select the desired submenu item and confirm
again. The value or status can now be set as desired, confirm each entry.
VOLUME
SPLAY ANGLES
SATELLITES
EQUALIZER
DELAY
DELAY TIME
x.x ms/m/ft
DELAY UNIT
TEMPERATURE
x °C / °F
TEMP. UNIT
To exit the menu level, select the arrow icon and confirm the selection.
ON / OFF
GAIN
-20 – +10
-20 – +10
-20 – +10
-20 – +10
A
0.0
ms
A
4
Sat
LVL
VOL
Set the delay time in the selected delay unit
ms
Delay unit milliseconds
m
Delay Unit Meter
ft
Delay Unit Foot
Set ambient temperature in the selected temperature unit
°c
Temperature unit Celsius
°F
Temperature unit Fahrenheit
EQ
NO FREQ
Q
6
30 – 20000 0.1 – 10.0
7
30 – 20000 0.1 – 10.0
8
30 – 20000 0.1 – 10.0
9
30 – 20000 0.1 – 10.0
10 30 – 20000 0.1 – 10.0 / HS -20 – +10
ON / OFF
GAIN
-20 – +10
-20 – +10
-20 – +10
-20 – +10
15
Publicité
