Pelgrim GVW765ONY Notice D'utilisation page 32

To interrupt a programme which is running,
open the door and then select the "pre-rinse
programme"( + ). Next, close the door.
After a few minutes, the dishwasher will move
to the setting "end of cycle" ( ). You can
now take the tableware out of the dishwasher.
Delaying the start time (depending on the
dishwasher model)
Switch on the appliance with button
The indicator lamps and are now
on.
Select a programme with the knobs 1-5.
See table on page 22.
Delay the start time of the programme with
button .
By pressing it once you delay the start time
by one hour; by pressing it twice you delay
the start time by two hours, and so on. You
can delay the start time by a maximum of
nine hours.
The number of hours by which you have
delayed the programme is visible on the
display .
Set the start time to 0 if no delay is desired.
Press button . The indicator lamp
goes out.
Trouble shooting
If the machine does not work properly, first
check if you can solve the problem yourself
with the help of the accompanying table.
Often the cause of the problem is something
very small.
The programme does not start
cause remedy
The plug is not in the Put the plug in the socket.
socket.
The door is not closed Close the door.
properly.
.
Defective fuse in Check the fuse-box.
the fuse-box.
No water in the appliance
cause remedy
The water tap is not on. Turn the water tap on.
There is a kink in Make sure the water inlet
the water inlet hose. is hanging freely.
Programme interrupted
cause remedy
The water tap is not on Turn the water tap on fully.
fully.
The tap filter is dirty. Clean the tap filter.
The trap cap of the siphon Place the trap cap in the
is not in place. siphon.
The kitchenware is not clean
cause remedy
Wrong programme. Select the correct washing
programme.
Spray arms blocked. Make sure that the spray
arms can rotate freely.
Check that the kitchenware
has been loaded properly.
Clean the filters.