Publicité
en first time
Note: If a water softening system is
installed in your house, you can se-
lect "Water softening system".
Tip: You can change the settings at
any time.
→ "Basic settings", Page 61
7.3 Water filter
You can use a water filter to minimise
limescale deposits and reduce impur-
ities in the water.
Inserting and activating the water
filter
ATTENTION!
Possible damage to the appliance
due to limescale build-up.
▶
Change the water filter in good
time.
▶
Change the water filter after
2 months at the latest.
▶
Observe the display messages.
Note: If "Please replace or deactivate
water filter in menu." is shown on the
display, replace the water filter.
If you are not inserting a new filter,
select "No filter" and follow the in-
structions on the display.
Immerse the water filter in a glass
1.
of water and press the sides to-
gether lightly until no more air
bubbles rise to the surface.
8
→ Fig.
Press
.
2.
Press
or
3.
.
Use
or
4.
or "Replace water filter" and press
.
1
Depending on the appliance specifications
52
1
"Water filter" and
to select "New filter"
Note: If you are not inserting a new
5.
filter, select "No filter" in the menu
settings.
Press the water filter firmly into the
water tank.
Fill the water tank up to the "max"
6.
mark and press
Connect the milk tube to the milk
7.
system and the suction pipe.
Insert the end of the suction pipe
8.
in the drip plate.
Place a container with a capacity
9.
of 1 litre under the outlet system
and press
The filter will be rinsed and the fol-
a
lowing message displayed: "Rins-
ing complete.".
The appliance is ready to use.
a
Tips
You should also change your wa-
¡
ter filter for reasons of hygiene.
With a water filter you need to de-
¡
scale your appliance less fre-
quently.
If your appliance has not been
¡
used for a long time, for example if
you were on holiday, you should
rinse the water filter before use by
dispensing a cup of hot water.
The water filter can be purchased
¡
from retailers or customer service.
→ "Accessories", Page 50
7.4 Performing initial start-up
After connecting the appliance to the
power supply, configure the settings
for initial start-up. Initial start-up only
appears when switching on for the
first time.
Press
to switch on the appli-
1.
ance.
The display will show the language
a
that is preset.
.
.
Publicité
