Publicité
How to Use
Start Vacuuming & Mopping
1. Take out the 2-in-1 dust compartment with water tank, open the plug, fill with
clean water, and then refasten the plug. Install the 2-in-1 dust compartment
with water tank onto the robot vacuum in the direction indicated in the
figure, and make sure that the clip is firmly clasped.
Clip
It is properly installed
when you hear a "click".
CAUTIONS:
Please remove the 2-in-1 dust compartment with water tank before adding water. Do not
add liquids such as hot water, detergent, or disinfectant to prevent damaging the robot
vacuum.
Due to production testing, the 2-in-1 dust compartment with water tank may have water
stains, which is normal.
2. Before using the vacuuming & mopping function, dampen the mop pad and
wring it out and then install it onto the mop pad holder. Slide the mop pad
holder along the bo om of the robot vacuum horizontally in the direction
indicated in the figure until it clicks into place.
Plug
Open the plug and
add water.
10
3. Press the bu on
to start vacuuming and mopping.
CAUTIONS:
Remove the 2-in-1 dust compartment with water tank and pour out the le over water in a
timely manner a er a mopping task has been completed. Then clean and dry the mop pad
to prevent odor and mildew.
When the robot vacuum is running, please set up virtual walls or restricted areas for
carpeted areas in your home to avoid the robot vacuum from becoming entangled in the
carpet.
If only vacuuming function is needed, please remove the
mop pad holder.
Clips
Press the clips and pull
the mop pad holder out.
Publicité
