Publicité
3. Release the latch pin so that it goes completely through the hole in the V-brace and through the back of the welded bracket
as shown in figure 7.
4. Insert the safety pin into the hole in the latch pin. See figure 8.
7
6
SETUP
RAPIDCLIMB STIRRUPS
Adjust the stirrups to fit your footwear at ground level. This
is done by loosening the wing-nut and sliding the stirrup up
or down the tube. Re-tighten the wing-nut once desired fit
is achieved. NEVER remove the wing-nut or stirrups. NEVER
slide the stirrup outside of the acceptable adjustment range
showed in figure 9 and 9b.
!
Moving your foot placement closer to the tree changes
the leverage needed to adhere the platform to the tree.
Attaching the stirrups or placing your feet too close to
the tree may cause the platform to slide down the tree
which could cause serious injury or death. See figure 9
and 9b for proper foot location.
The stirrups on the Explorer Folding Treestand models pivot
up when not in use or when packing the stand together. See
figure 10.
10
All manuals and user guides at all-guides.com
DO NOT use the Explorer if the latch pin is not
completely inserted through the hole in the V-Brace as
shown in figure 7 and if the safety pin has not been
fully inserted as shown in figure 8.
WARNING
8
WARNING
!
9
ACCEPTABLE ADJUSTMENT RANGE
SENTRY
EXPLORER
9b
PG 7
Publicité
