Publicité
8
CLIMBING UP / USE / CLIMBING DOWN
CLIMBING UP WITH YOUR NEW STAND
WARNING
!
At this point IT IS MANDATORY AND REQUIRED
that you attach your FBFAHS to the tree and
remain connected at all times after leaving the
ground.
ALWAYS refer to the written FBFAHS instructions
and videos for proper and safe use of your FBFAHS
before climbing.
WARNING
!
DO NOT use the Explorer if the latch pin is not
completely inserted through the hole in the
V-Brace and if the safety pin has not been fully
inserted as shown in figure 8.
1. Following the FBFAHS Instructions, attach the
harness tether to the tether strap. Loop the strap
around the tree to secure it. See figure 36.
2. Your RapidClimb stirrups and bungee heel cord
should be already attached to your treestand. To use,
back your heel into the bungee heel cord (figure 37)
then simply slide your boot under the RapidClimb
stirrup. Make sure that your boot is secure under the
stirrup as shown in figure 38.
3. On the Explorer, hook the seat back elastic bungee
cord around the seat as shown in figure 39 to keep it
secure while you climb. On the Sentry, pivot the seat
down to sit or leave it against the V-Brace to stand.
4. To begin climbing, raise your seat climber up to
just below waist height and grasp the upright arms
very firmly as shown in figure 40.
NOTE: On the Sentry models, use the green
tourniquet strap to secure the seat frame in the up
position.
PG 14
All manuals and user guides at all-guides.com
36
38
(OPEN FRONT STANDS)
COBRA SHOWN, EXPLORER /
SENTRY SIMILAR
COBRA SHOWN, EXPLORER /
SENTRY SIMILAR
40
37
39
www.summitstands.com
Publicité
