Télécharger Imprimer la page

Sanitas SWB 30 Mode D'emploi page 14

Chauffe-matelas
Masquer les pouces Voir aussi pour SWB 30:

Publicité

4.2 Initial use
• Spread out the heated underblanket flat onto your mattress starting at the foot end.
• To operate the heated underblanket connect the control to the heated underblanket by
plugging in the connector.
• Then plug in the supply plug into the mains outlet.
• Then put on your bedsheet in the usual manner so that the heated underblanket is
between your mattress and the bedsheet
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
4.3 Switching on
To switch on the electric underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.
4.4 Setting the temperature
Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the control, first.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overheat­
ing of the user.
4.5 Switching off
To switch off the electric underblanket, set the slider for ON/OFF and temperature settings to the OFF (0)
position. The temperature settings are then no longer illuminated.
NOTE:
If the electric underblanket is not used for several days, set the slider for ON/OFF and temperature
settings to the OFF (0) position and remove the mains plug from the socket.
5. Cleaning and maintenance
WARNING
Always remove the supply plug from the mains outlet and remove the control from the heated under­
blanket by disconnecting it at the connector. Otherwise there is a risk of an electric shock.
CAUTION
The control must never come into contact with water or other liquids, as this may cause damage.
• To clean the control, use a dry, lint­free cloth. Do not use cleaning agents containing solvent or scouring
agents.
• To remove stains from the heated underblanket use a damp cloth and, if necessary, a mild cleaning agent.
14

Publicité

loading

Ce manuel est également adapté pour:

Swb 50