Publicité
English
1) do not push Stapler on workpiece with strong force;
2) take Stapler away from workpiece using recoil;
3) release trigger quickly when performing trigger fire.
Do not drive staples into thin boards or near corners and edges
of workpiece. Staples can be driven through or away from
workpiece and hit someone.
Never drive staples from both sides of a wall at the same time.
Staples can be driven into and through the wall and hit a person
on the opposite side.
Never use Stapler which is defective or operating abnormally.
Do not use Stapler as hammer.
Disconnect air hose from Stapler when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
This Hitachi Stapler has a STANDARD CONTACT TRIP MECHANISM (Bounce File). An
OPTIONAL SEQUENTIAL TRIP MECHANISM kit (SINGLE SHOT) is available as order part
number 882332.
THE STANDARD CONTACT TRIP MECHANISM (Bounce Fire) is for use where rapid fastener
placement is desired and must be operated in accordance with the following "Methods of
Operation".
METHODS OF OPERATION
This Stapler is equipped with the push lever and does not operate unless the push lever is
depressed (upward position).
There are two methods of operation to drive staples with this Stapler.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever fire):
(1) Intermittent operation (Trigger fire)
1 Position the staple outlet on the
workpiece with finger off the trigger.
2 Depress the push lever firmly until it is
completely depressed.
3 Pull the trigger to drive a staple.
4 Remove finger from the trigger.
To drive another staple, move the Stapler
along the workpiece and repeat this
procedure.
18
All manuals and user guides at all-guides.com
Push Lever
3
Trigger
2
Publicité
