Publicité
ASSEMBLY INSTRUCTIONS
7. Attach the large rubber sealing gasket to the center drain
hole under the tank.
Hardware Used
Large Rubber Sealing
HH
Gasket
8. Gently place the tank on the bowl with the bolts protruding
out underneath. Then tighten with metal oval washers
and wing nuts, tighten enough that the tank sits flat on the
bowl.
Make sure that the toilet tank is parallel to the wall and
straight on the bowl.
CAUTION: DO NOT OVERTIGHTEN NUTS, SEVERE
DAMAGE MAY OCCUR.
Hardware Used
FF
Oval Washers
GG
Wing Nut
9. Unscrew the tightening nut which is attached to the push
button mechanism.
Insert the push button body through the tank lid hole.
Tighten with the large nut supplied.
Hardware Used
AA
Chrome Push Button
x 1
x 2
x 2
x 1
8
7
8
9
Publicité
