Resetting Input Name To Default Name; Remote Control - Nagra CLASSIC INT Manuel De L'utilisateur

Resetting input name to default name

If you are unhappy with the renaming of the inputs, you can reset
all the input names to factory settings. Go to the « In. Names »
Menu:
In.Names
Edit
Restore
Confirm
Press once again, the factory names have been restored.

Remote control

The CLASSIC INT comes with a Nagra RCU III remote control.
This remote control uses standard RC5 codes from Philips. It is
called RC5 in the menu.
However, you may also control it with the classic Nagra RCU or RCU
II remote (supplied with the Nagra CD range).
Remote
RC5
Then press once to validate your choice.
Press the knob once.
« Edit » displays.
Rotate the knob until « Restore » displays.
Press the knob once again, « Confirm »
displays.
Inside the menu, rotate the knob until
« Remote » displays then press it once to
enter remote control selection.
« RC5 » displays, rotate the knob to select
the remote control you want the amplifier
to be controlled with i.e. Device 1, etc...
39
NAGRA – CLASSIC INT