Publicité
5. OPERATING INSTRUCTIONS
5.1 OVERVIEW
1 Base foot
2 Quick clamping base foot
3 Quick clamping telescopic pipe
4 Tool shelf
5 Upper telescopic pipe
6 Handlebar bracket
7 Frame clamps
8 Quick closure frame clamps
9 Locking mechanism for folding joint
10 Unlocking mechanism for rotating mechanism
11 Locking lever for rotating mechanism
7
6
3
8
Figure 1: Overview
The bicycle assembly rack is, for the most part, already
pre-assembled. You only need to mount the tool shelf and
handlebar bracket.
5.2 SETTING UP THE BICYCLE ASSEMBLY RACK
Fold the base foot out (Position 1 in the Overview).
Secure the base foot in position using the quick clamp (
Position 2 in the Overview). To do this, fold the lever of the
quick clamp up to the pipe. If this is not secure enough,
fold the lever back and rotate it clockwise 1 or 2 turns on
the thread. Then fold the lever of the quick clamp back up
to the pipe. Repeat this procedure until the base foot is
su ciently secured.
6
9
Pull the upper telescopic pipe out (Position 5 in the
Overview). Secure the telescopic pipe with the quick clamp
(Position 3 in the Overview) by folding the lever up to the
pipe. If this is not secure enough, fold the lever back and
rotate it clockwise 1 or 2 turns on the thread. Then fold the
lever of the quick clamp back up to the pipe. Repeat this
procedure until the upper telescopic pipe is su ciently
secured.
Fold the head, with the frame clamp (Position 7 in the
Overview) into the working position, Figure 2. Secure the
head by pushing the lever of the locking mechanism into
place (Position 9 in the Overview). If this is not secure
enough, fold the lever back and rotate it clockwise 1 or 2
turns on the thread. Then fold the lever back up to the pipe.
Repeat this procedure until the head is su ciently secured
with the frame clamp.
5
4
Figure 2
Fit the tool shelf (Position 4 in the Overview) into the
2
bracket on the lower telescopic pipe.
5.3 SECURING A BICYCLE
1
First open the frame clamp (Position 7 in the Overview)
by folding up the lever of the quick closure (Position 8 in
the Overview) and rotating anti-clockwise. Open the frame
clamp just enough to enable the pipe of the bicycle frame
10
to be inserted between the clamping jaws. If the frame
clamp is opened too wide, it is not possible to secure the
bicycle rmly by closing the quick closure lever. You may
11
need a few attempts to work out how to set the frame
clamp before you tension the bicycle in the assembly rack.
There is a risk of injuries if the bicycle falls out of
the frame clamp.
If possible, have a second person to help you
tension a bicycle in the assembly rack.
If possible, the bicycle should be placed in the assembly
rack in such a way that the frame clamp is positioned over
the centre of gravity of the bicycle. Now place the bicycle in
the frame clamp and close the quick closure. Pay attention
to ensure that none of the brake cables or electrical lines
are trapped and damaged. Check to ensure that the
assembly rack is safely positioned.
Publicité
