Publicité
.-
GRAPHIC EQUALIZER
MANUAL TUNING
ROCK
POP
CLASSIC
c1
FT
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble.
Press one of the GRAPHIC EQUALIZER
buttons.
To cancel the selected mode
Press the selected button again. "GEQ OFF is displayed.
To select with the remote control
Press the GEQ button repeatedly while pressing the SHIFT
button. The GEQ mode is displayed cyclically as follows.
ROCK —
POP —
CLASSIC —
GEQ OFF
(cancel)
Sound may be distorted when the ROCK or CLASSIC is selecte~
in which low frequency sound is originally emphasized. In this
case, cancel the selected mode.
1
2
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
plug (a6.3 mm,
'/4
inch).
No sound is output from the speakers while the headphones
are plugged in.
Sound adjustment
during recording
The output volume and tone of the speakers or headphones
may be freely varied without affecting the recording.
.,(,
—.
+..
-%
,.
Press the TUNER/BAND
button
repeatedly
to
select the desired band.
FM —
AM
When the TUNER/BAND button is pressed while the power
is off, the power is turned on directly.
To select a band with the remote control
Press the BAND button while pressing the SHIFT button.
Press the 44
DOWN or _
UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, i[[~ll)
is displayed.
([1?1)1
TUNE
To search for a station quickly (Auto Search)
Keep the +
DOWN or ->
UP button pressed until the tuner
starts searching for a station.
After tuning in to a station, the
search stops,
To stop the Auto Search manually, press the 4+
DOWN or >
UP button.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast
contains noise
Press the MONO TUNER button while pressing the SHIFT button
on the remote control so that '[MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons so that "MONO
disappears.
To
change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
7
ENGLISH
Publicité
