Publicité
Al EDIT RECORDING
The Al edit function enables CD recording without worrying about
tape length and track length. When a CD is inserted, the unit
automatically calculates the total track length. If necessary, the
order of tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)
1
2
3
4
5
6
4,8
5
6
4,8
Insert the tape to be recorded on into deck 1, and
wind up to the beginning
of the front side.
Press the W4
button to open the cassette holder and insert
the tape with the exposed side down. Wind up the tape with
the -
button,
Press the CD button.
Load discs onto the trays.
Press
the
EDIT/CHECK
button
once
while
pressing the SHIFT button on the remote control.
"EDl~ and "Al" are displayed.
EDIT
Each time it is pressed, the display changes as follows.
Press one of the DISC DIRECT PLAY buttons to
select a disc.
If only one disc is inserted, skip this step.
Press
the numbered
buttons
on the remote
control to designate
the tape length.
10 to 99 minutes can be specified.
Example:
When using a 60-minute tape, press the 6 and O
buttons.
In a few
seconds,
the microcomputer
programes
the tracks
to be recorded on each side of the tape.
The U
and ~
buttons are also available to designate
the tape length.
Programmed
tracks for side A
7
8
9
Press the
button on deck 1 to start recording
on the first side.
CD play and recording of edited tracks for the first side start
simultaneously. When the end of the tape is reached, deck 1
enters the recording stop mode. After entering the recording
stop mode, go to step 8.
Press the EDIT/CHECK
button while pressing the
SHIFT button on the remote control to display
the program for the second recording.
B is displayed.
Turn over the tape in deck 1 and press the
button to start recording
on the second side.
To
stop recording
Press the
j=
button on deck 1. Recording and CD play stop
simultaneously.
To clear the edit program
Press the
CLEAR button for CD twice in stop mode so that
"EDIT" disappears on the display or the 4 OPEN/CLOSE button
for CD.
To check the order of the Droctrammed track numbers
Before recording, press the EDIT~CHECK button while pressing
the SHIFT button on the remote control to select side A or B,
and press the +
or PF button repeatedly.
Programmed
track numbers
I
Track number
Program number
To add tracks from other discs to the edit program
Use the remote control.
If there is any time remaining on the tape after step 6, you can
add tracks from other discs in the CD compartment
1
Press the EDIT/CHECK
button while pressing the SHIFT
button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numbered buttons to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a littIe longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
m
The edit function cannot be used with discs containing 31 tracks
or more.
Tape length
I Remaining time of recording
Tape side
A: First recording side
B: Second recording side
13
ENGLISH
Publicité
