Publicité
SETTING THE CLOCK
SETTING THE SLEEP TIMER
1
1
1 Press
the CLOCK
button
while
pressing
the
SHIFT button on the remote control, and press
the 11 SET button within 4 seconds.
2
Press
the +
DOWN
or -
UP button
to
designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
3 Press
the -
D.OWN or -
UP button
to
designate
the minute,
and press
the II
SET
button.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the
button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
~
This is caused by a power interruption. The current time needs
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
1
2
The unit can be turned off automatically at a specified time.
Use the remote control
1
2
Press the SLEEP button while pressing the SHIFT
button.
Within 4 seconds,
press the <
or -
button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps
Specified time
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that "SLEEP oFF appears on the display.
15
ENGL/SH
Publicité
