Publicité
a
1- Position the motor on the DOWN end limit using the DOWN and UP
keys.
2- To memorize the DOWN end limit position, press simultaneously
the STOP and UP keys. The motor will run automatically in the UP
direction.
3- Before the motor reaches the UP end limit, press the Stop key.
4- After the adjustment of the DOWN (a) and the UP (b) end limits, confirm the settings:
- Press 2s on the Stop key to validate the settings. The motor will stop and will run for 0,5 second in
one direction and then in the other. Go to next step.
If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
* In this case, the motor will run for 0,5 second in both directions, that means the limits setting is already done.
5
Programming the first individual point of control
This operation can only be performed from the transmitter that was used for operation 4.1.
- Press the transmitter PROG Key for approximately 1 second. The
motor will run for 0,5 second in one direction and then in the other.
Your transmitter is now programmed to control the motor in
stable mode.
6
Programming a new (individual, group or main) control point:
6.1- Open the memory of the receiver from the control
transmitter:
- Press the PROG key of the transmitter for about 3 seconds.
The motor will run for 0,5 second in one direction, then in the
other.
6.2- Validate the operation from the new transmitter you
want to program:
- Press the PROG key of the transmitter for about 1 second. The
motor will run for 0,5 second in one direction, then in the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For main controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter, then
perform the operation 6.2 with the transmitter to be deleted.
7
Recording / controling / deleting intermediate position
Recording:
- Position the motor on the wanted
position.
- Press 5 seconds on the Stop key.
The motor will run for 0,5 second in
one direction and then in the other.
Deleting : Position the motor on the intermediate position. Press 5 seconds on the Stop key, the intermediate
position is deleted.
All manuals and user guides at all-guides.com
b
1- Position the motor on the UP end limit using the UP and DOWN
keys.
2- To memorize the UP end limit position, press simultaneously the
STOP and DOWN keys. The motor will run automatically in the
DOWN direction.
3- Before the motor reaches the DOWN end limit, press the Stop key.
Controling:
- Press on the Stop key for
0.5 s. the motor goes to the
intermediate position.
3/4
Publicité
