OBJ_BUCH-432-004.book Page 18 Monday, July 6, 2009 8:15 AM
18 | English
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 609 929 S92 | (6.7.09)
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Rotating handle (SDS system)
(insulated gripping surface)
2 Thumbwheel for stroke rate preselection
(GST 85 PBE/GST 2000)
3 On/Off switch
4 Lock-on button for On/Off switch
5 Allen key
6 Switch for sawdust blowing device
7 Adjusting lever for orbital action
8 Base plate
9 Guide roller
10 Saw blade*
11 Contact protector
12 Handle (insulated gripping surface)
13 Stroke rod
14 Splinter guard*
15 Scale for mitre angle
16 Screw
17 Positioning pin/mark
18 Bolt hole
19 Lead for the parallel guide
20 Locking screw for parallel guide*
21 Parallel guide with circle cutter*
22 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools