Publicité
Installation
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls. Check if the rear wall
clearance protection component is
present at its location (if provided
with the product). If the component
is not available, or if it is lost or fallen,
position the product so that at least
5 cm clearance shall be left between
the rear surface of the product and
the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
3.3 Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front
by rotating them to the right or left.
3.4 Electrical Connection
WARNING: Do not make
A
connections via extension
cables or multi-plugs.
WARNING: Damaged
B
power cable must be
replaced by the Authorized
Service Agent.
If two coolers are to be
installed side by side, there
C
should be at least 4 cm
distance between them.
• Our company shall not be liable
for any damages that will arise
when the product is used without
grounding and electrical connection
in accordance with the national
regulations.
• Power cable plug must be within easy
reach after installation.
• Do not extension cords or cordless
multiple outlets between your
product and the wall outlet.
C
12 / 23 EN
Hot Surface Warning!
Side walls of your product
is equipped with refrigerant
pipes to improve the cooling
system.
Refrigerant
high temperatures may flow
through these areas, resulting
in hot surfaces on the side
walls. This is normal and does
not need any servicing. Please
pay attention while touching
these areas.
Refrigerator/User Manual
with
Publicité
