SilverCrest SKM 600 C2 Guide De Démarrage Rapide page 20

Basic operation
Power supply
DANGER! Risk of electric
shock!
Only connect the mains plug 3 to a
properly installed and easily accessible
wall socket whose voltage corresponds
to the specifications on the rating plate.
The wall socket must still be easily ac-
cessible after the device is plugged in.
NOTE: when the device is used the first few
times, some odour may be generated by the
device due to the heating of the motor. This
is harmless. Please ensure adequate ventila-
tion.
1. Assemble the device for the desired
function.
2. Check that the speed control 2 is set to
0 (off).
3. Plug the mains plug 3 into a suitable
wall socket. The wall socket must still be
easily accessible after connection.
4. Pull out the mains plug 3 before clean-
ing the device.
Switching the device on/off and
selecting speed
WARNING! Risk of material damage!
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
NOTE: the device may move slightly while
you are processing large quantities of
dough.
1. Switch the device on by turning the
speed control 2 clockwise.
2. Start at a slightly lower speed, and
slowly increase to the desired speed.
18 GB
3. Reduce the speed to speed 1 - 2 when
you are adding ingredients during oper-
ation through the filling opening 11.
4. Set the speed control 2 to 0 to switch
the device off.
Pulse function
• By turning the speed control 2 to the po-
sition , you can briefly increase the
speed to the highest setting (8).
For additional information, please
consult the online user instructions.