SilverCrest SKM 600 C2 Guide De Démarrage Rapide page 17

Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must still be easily ac-
cessible after the device is plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot spots.
Do not wrap the power cable around
the device.
Even after it has been switched off, the
device is not completely disconnected
from the mains power supply. In order
to fully disconnect it, pull out the mains
plug.
Keep the power cable away from hot
surfaces (e.g. hot plates).
When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull on the plug and
never the cable.
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you are not using the food pro-
cessor,
... prior to assembling or disassembling
the food processor,
... prior to cleaning the food processor
and
... during thunderstorms.
Do not use the device if there is visible
damage to the device, accessories or
power cable.
To avoid any risk, do not make modifi-
cations to the product.
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
Do not touch rotating parts with spoons
or similar utensils. Keep long hair and
loose clothing away from the rotating
parts.
Always ensure that the speed control is
set to 0 before you plug the mains plug
into the wall socket.
Switch the device off and pull out the
mains plug from the wall socket before
you exchange auxiliary equipment or ac-
cessories that move while in operation.
Place the device exclusively on a level,
dry, non-slip and waterproof surface, so
that it can neither fall nor slip off.
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
The device must never be operated with-
out the container.
Never place the device on a hot sur-
face, e.g. a hot plate.
Do not change the position of the de-
vice, as long as there is still food or
dough in the device.
Never overfill the mixing bowl, since
otherwise the contents could be ejected.
Overflowing liquid would flow onto the
surface. You should therefore place the
device on a waterproof surface.
Do not operate the device when it is emp-
ty, as this causes the motor to overheat
and may result in it becoming damaged.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.
The beater and dough hook have a non-
stick coating. Do not damage them with
sharp, pointed or scratching objects
(e.g. knife, scourer).
The device is equipped with non-slip plas-
tic suction feet. As furniture is coated with
a wide array of varnishes and plastics
and is also treated with different care
products, it cannot be fully ruled out that
some of these materials contain compo-
nents that could attack and soften the
non-slip plastic suction feet. If necessary,
place a non-slip mat under the device.
15
GB