SilverCrest SKM 600 C2 Guide De Démarrage Rapide page 18

Unpacking and setting up
1. Remove all packing material.
2. Check to ensure that all parts are pres-
ent and undamaged.
3. Disassemble the device.
4. Clean the device prior to first use!
5. Figure A: wind the excess power
cable 3 around the cable spool 14 on
the underside of the base unit 9.
6. Place the base unit 9 on a level, dry
and waterproof surface, so that the de-
vice can neither fall nor slip off.
Select a smooth, clean surface, so that
the suction feet 8 can stick firmly in
place and ensure a secure grip.
CAUTION:
Overflowing liquid would flow onto the
surface. You should therefore place the
device on a waterproof surface.
Dismantling the device
DANGER from rotating parts!
Turn off the device and unplug the
mains plug 3 from the wall socket be-
fore disassembling the device.
1. Press the unlock button 1 and fold up
the drive arm 13 until it engages and
the unlock button 1 pops out again.
2. Figure C: turn the mixing tool 4/6/7
in the direction of the arrow until it can
be pulled downwards off the axle 10.
3. Turn the splash guard 12 towards the
open lock symbol until it can be removed.
4. Turn the mixing bowl 5 towards the open
lock symbol until it can be removed.
5. Press the unlock button 1 and move the
drive arm 13 all the way down. The un-
lock button 1 pops out again.
16 GB
Cleaning and servicing
the device
DANGER! Risk of electric
shock!
Disconnect the mains plug 3 from the
wall socket before each cleaning.
Never immerse the base unit 9 in water.
WARNING! Risk of material damage!
Never use any abrasive, corrosive or
scouring cleaning agents. These might
damage the device.
After every use
• Clean the device and all accessories
used after each use and remove all food
residues.
• All accessories must be disassembled
and individually cleaned.
For additional information on clean-
ing and looking after the device and
accessories, please see the online
user instructions.
Using the mixing tools
1. Press the unlock button 1 and fold up
the drive arm 13 until it engages and
the unlock button 1 pops out again.
2. Place the mixing bowl 5 into the base
unit 9 in such a way that the metal pins
on the lower edge fit into the recesses in
the base unit.
3. Lock the mixing bowl 5 by turning it to-
wards the closed lock symbol until it is
firmly seated.
CAUTION:
Never use the mixing bowl 5 without
the splash guard 12 attached. The ma-
terial you are mixing could otherwise
be ejected.