Publicité
Fitting the air intake filter
• Remove the transportation cover from the air filter connection with a screwdriver, then
screw in the supplied air intake filter (1). Fig. 6 refers.
Fig. 4
Replacing the oil sealing plug
• Remove the transportation cover from the oil filter opening with a screwdriver, then insert
the supplied oil sealing plug (14) into the oil filter opening. See Fig. 7.
• Make sure the motor has sufficient engine oil before starting the compressor. Refer to clause
6.2 for details.
Power supply
• Use the original power cord and plug supplied with the product.
• The compressor must be connected to the 220-240V ~ 50Hz mains supply.
• Long cables, extensions, cable reels... etc. cause a drop in input voltage and can impede
motor start-up.
• In case of ambient temperature below +5 °C, motor start-up is jeopardized as a result of
stiffness.
4.3- Power On/Off
• To turn on the compressor, turn the power switch (8) to the ON position.
• To turn off the compressor, turn the power switch (8) to the OFF position.
Fig. 5
Fig. 7
Fig. 6
Page 14 / 28
Publicité
