Publicité
or medical purposes after special treatments only and cannot be used to fill divers' air
cylinders.
• Never leave the device in bad weather.
• The air compressor must be installed in a suitable and well-ventilated environment, the
ambient temperature must be between +5 and +40°C.
• The work area must be free of dust, acid vapors, explosive gases and flammable materials.
• Do not exceed the maximum air pressure rating for the accessory.
• Use only hoses or connectors designed for use with compressed air. The maximum working
pressure of the hoses and fittings must be greater than the maximum working pressure of the
compressor.
• This compressor must be connected to main electricity protected by an appropriate circuit
breaker or fuse.
• Use extension cables with a maximum length of 5 meters.
• Always use the handle to move the compressor. Do not attempt to move the compressor by
pulling on the air hose or electrical cable.
• During operation, the compressor must be securely installed on a stable and horizontal
surface.
• Avoid kinking or pinching the air hose.
• When using compressed air, you must observe and follow the safety precautions for the type
specific application (such as inflation, pneumatic tools, painting, washing with water-based
detergents, etc.).
• The pump and compressor lines may become very hot during operation. Avoid touching
these parts during operation.
• Empty the tank after each use. Turn off and slowly open the drain valve to release the air,
then tilt the compressor to drain the condensed water.
• Always transport the compressor by lifting or pulling it with the appropriate grips or
handles.
• Always replace defective hoses - never attempt to repair if a leak is detected.
• Keep the engine vent clear and free of dust, wipe it regularly to maintain an adequate supply
of clean air to the air compressor.
• Never clean the compressor with flammable liquids or solvents. Make sure you have
unplugged the compressor and clean it with a damp cloth.
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
4.2- Assembly
WARNING!
Before starting assembly or changing accessories, turn it off and disconnect from main
power source.
Fitting the wheel
• Fit the supplied wheel (3) with screw and washer provided. Fig. 4 refers.
Fitting the supporting foot
• Fit the supplied supporting foot (4) to the leg with screw and washer provided. Fig. 5 refers.
Page 13 / 28
Publicité
