Publicité
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Important!
For optimum suction results and battery power
performance it is always best to use batteries with
the same capacity of 3.0 Ah or higher.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The equipment's operating time depends on the
battery with the lower charge level. The two bat-
teries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
Fitting the battery (Fig. 8)
Fold the battery cover (19) up as shown in Figu-
re 8. Then insert the two batteries (20) into the
mounts.
Battery capacity indicator (Fig. 12b/23)
Press the switch for the battery capacity indicator
(a). The battery capacity indicator (Fig. 23) shows
the charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
GB
5.6 Charging the transmitter
You must fully charge the battery before you use
it for the fi rst time and after it has spent a long
period in storage.
Transmitter status LED
during charging
Flashing
Off
Charging takes approx. 2 hours.
5.7 Coupling the transmitter (Fig. 1)
1. Set the On/Off /Vacuum setting switch (2) to
position I
2. Set the connectivity switch (42) to position I
3. Keep the receiver button (40) pressed until
the status LED (39) begins to fl ash
4. Immediately press the transmitter button (44)
once
5. The receiver status LED (39) will light up for 3
s - the transmitter is coupled.
5.8 Decoupling the transmitter (Fig. 1)
1. Set the On/Off /Vacuum setting switch (2) and
the connectivity switch (42) to position I
2. Press the receiver button (40) 5 times in quick
succession
3. The receiver status LED (39) will light up for 3
s - the transmitter is decoupled
6. Operation
6.1 On/Off switch (Fig. 1/2)
Switch position 0: Off
Switch position I: Vacuum setting 1
Switch position II: Vacuum setting 2
6.1.2 Connectivity switch (Fig. 1/Item 42)
Switch position 0:
Switch position I:
6.1.3 Using without connectivity (Fig. 1)
Set the connectivity switch (42) to 0. The equip-
ment can then be used via the On/Off /Vacuum
setting switch (2) in the mode required (switch
position I or II).
- 21 -
Meaning
The battery is being
charged
The battery is charged;
the transmitter is ready
for use
Connectivity off
Connectivity on
Publicité
