Publicité
EN
Special care must be taken during cleaning. Cleaning should only be done with the tool switched off
and disconnected from the power supply to avoid injury. Ensure that the cord and any used
extension cord is not damaged, is properly coiled and not kinked.
Pull the plug from the power supply:
Before putting the tool down on the ground.
Before removing objects causing blockage.
Before checking, cleaning or performing any work on the tool.
If the tool accidentally sucks up an object, stop the tool immediately and do not use it until it has
been checked and you are certain that the tool is safe to use.
If the tool makes an unusual noise or starts to vibrate abnormally, stop operation immediately,
unplug the tool from the power supply and investigate the cause. Excessive vibration can cause
damage to the tool and injury to the operator.
Residual risks
Even when the tool is used as intended, it is not possible to eliminate all risks. The following
hazards may arise from use of the tool:
1) Damage to the lungs if a dust mask is not used.
2) Damage to hearing if hearing protection is not used.
3) Health problems due to vibration emission if the power tool is used continuously for long
periods of time or is not properly maintained.
WARNING! This tool generates an electromagnetic field during operation. This field may in some
cases interfere with active or passive medical implants. To reduce the risk of serious injury or death,
persons with medical implants should consult their physician and the medical implant manufacturer
before using the machine.
INTENDED USE
The machine should only be used to blow or collect leaves and debris. Improper use of the tool may
cause damage to the tool or serious injury to the operator.
ASSEMBLY AND ADJUSTMENTS
Warning!
The machine must not be used or switched on until it has been fully assembled.
Assembly
Take out out the two tubes, the body and the three screws. The user must assemble the
1.
tube (2-2). Insert the tube (2-1) forcibly. Tighten the screw until they are well connected.
See fig. 3, and then insert the entire tube into the machine body and fasten securely with
the other two screws, (see fig. 4).
8
WWW.NIKOLAOUTOOLS.COM
Publicité
