Publicité
ON/OFF
Located in the middle of the panel, the ON/OFF button must be pressed down before motor can be started.
Auger Control Trigger
Located on the left side of the handle, the Auger Control Trigger is used to engage and disengage the augers.
Squeeze the Auger Control Trigger to engage the augers; release to disengage the augers.
Drive Control Trigger
Located on the right side of the handle, the Drive Control Trigger is used to engage and disengage the drive
wheels. Squeeze the Drive Control Trigger against the lower handle to engage the wheels; release to
disengage.
Drive Speed Control
The Speed Control is located on the right panel and is used to set the drive speed and direction of travel. It can
be forward and reverse.
Chute Rotation Button
Located on the left side of the panel,push the button,chute should rotate 180 degrees.
Skid Shoe
Position the shoes based on the surface conditions. Adjust upward for hard-packed snow. Adjust downward
when operating on gravel or crushed rock surfaces.
Auger Blade and Impeller
When engaged, the auger blades rotate to cut snow and direct it into the auger/impeller housing to be
discharged out the chute.
Clean-out Tool
The chute Clean-out Tool is conveniently fastened to the rear of the auger housing with a mounting clip. It is
used to clean the chute assembly and chute opening when snow and ice become lodged.
WARNING! Never use your hands to clear a clogged chute assembly. Shut off machine and remain behind
handles until all moving parts have stopped before unclogging.
LED Light
Located on the front of the panel,this feature provides extra light for increased visibility.
OPERATION
WARNING: Do not allow familiarity with this product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict serious injury.
WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.
WARNING: Do not use any attachments or accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not recommended can result in serious personal
injury.
To Install Battery Pack
When not in use, battery pack should be stored in an enclosed area where the temperature will not
drop below -4°F (-20°C). Optimal charging temperatures are between 32°F (0°C) and 122°F (0°C -
50°C).
WARNING: If any parts are broken or missing, do not attempt to attach the battery pack
to the snow blower or operate the snow blower until the broken or missing parts are
replaced. Failure to do so could result in serious injury.
8
Publicité
