Publicité
GENERAL MAINTENANCE TIPS
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc.
come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic which can result in
serious personal injury.
LUBRICATING THE MACHINE
All of the bearings in this product are lubricated with a sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no further bearing lubrication is required.
AUGER OR IMPELLER JAMS
WARNING! The auger and impeller rotate at fast speeds which can cause harm or even amputation to a
person's body parts. Even if you do not see the auger or impeller rotating, it may start at any time if the
machine is running. Remove the Safety Key before cleaning the jams.
1.Always turn OFF the machine before attempting to clear any clogs or jams.
2.Keep hands and feet away from rotating parts while the machine is running.
3.Do not wear loose fitting clothing that can become entangled in rotating parts.
4.Wait until the auger and impeller have come to a full stop.
5.Clear any visible jams using the clean out tool attached to your machine.
WARNING! DO NOT try to clear jams with your hands or feet.
TROUBLESHOOTING
Problem
The snow thrower
does not start.
The motor is on,
but the impeller
does not turn.
NOTE: Please contact the customer service for any questions.
Cause
The battery is not charged.
The switch is defective
Battery is too cold.
The battery is not attached to
the motor.
Battery may require service or
replacement.
The belt is damaged.
Solution
Charge the battery by following the
procedures in the battery and charger
manual.
Have the switch replaced by an authorized
service center.
Remove battery from snow thrower. Place
battery on charger and allow to charge for 10
minutes. Remove from charger and install in
Snow thrower for use.
Check the connection between the motor
connector and the battery.
Call toll free helpline, at 1-872-314-0005
or replace battery.
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
13
Publicité
