Publicité
This service information describes the connection of the IntelliBridge to the Integra Licox device.
Data communication
The IntelliBridge EC10 module supports serial data communication with the following
communication settings on the Integra Licox.
• Signaling speed
• Character bits
• Stop bits
Instruction for connection
Connect the IntelliBridge EC5 D-Sub 9-pin connector to the USB connector of the Integra Licox
device as shown below, using the RS232 to USB connector cable as shown below.
IntelliBridge EC5 connection to RS-232 port
1
2
3
4
References
For further service information, refer to the patient monitor service guide.
Service Information
7
9600 Baud
8
1
Integra Licox - RS232 port
RS232 to USB connector cable
IntelliBridge EC5 ID module
EC5 device label: "Integra Licox"
453665075941
• Parity generation
• Parity checking
1
2
Even
Even
3
4
7
17
Publicité
