STOK QUATTRO SGP4033N Manuel D'utilisation page 11

REAR
PANEL
BOLT
(FF)
LEFT
SIDE
PANEL
SLOT
Fig. 6
STEP 2: ASSEMBLING SIDE PANELS TO THE
BASE
See Figure 6.
 Slide the tabs into the slots then sit the panel on the base
aligning the holes in the tabs at the bottom of the right
side panel with holes on the left side of the base.
 Slide bolts, M5 x 12 mm (FF), three per side, through both
the tab and into the base. Tighten securely.
 Repeat above steps to install the left side panel.
STEP 3: ASSEMBLING THE FRONT AND REAR
PANELS
See Figures 6 - 7.
Installing the rear panel:
 Place two bolts, M5 x 12 mm (FF), through the side of
the rear panel and into the side panel. Tighten securely.
Repeat for the other side.
 Place two bolts, M5 x 12 mm (FF), through the bottom of
the rear panel and into the base. Tighten securely.
ASSEMBLY
RIGHT SIDE
PANEL
Fig. 7
TAB
Fig. 8
Installing the front panel:
 From the front of the base, align the holes in the front
 Secure the front panel to the side panels using four bolts,
STEP 4: INSTALLING INSERT STORAGE
BRACKET
See Figure 8.
 Insert the wire frame of the insert storage bracket into
11 - English
BOLT
(FF)
BASE
panel with the holes at the top of the side panels.
M5 x 12 mm (FF).
the holes inside the cabinet.
FRONT
PANEL
INSERT
STORAGE
BRACKET