Publicité
pro.Bose.com
3.
Using the included T3 square drive, remove the plastic inserts on the rear panel of the loudspeaker and attach the bracket to
speaker using only the included M8 x 20mm screws.
4.
Hang the speaker on the wall-mounted half of the bracket and install the lower carriage bolt removed earlier.
5.
Adjust the pitch and yaw using the specified tightening torque.
8 ft-lb (11 Nm)
30°
7 ft-lb (9 Nm)
Installation and Safety Guidelines
M8 x 20mm
18 ft-lb (25 Nm)
Installation
English 13
Publicité
