Publicité
3.
SAFETY WARNINGS AND RECOMMENDATIONS:________________________________
The equipment should be assembled and handled by truly qualified people.
Current electrical and accident prevention regulations should be followed.
Under no circumstances will the manufacturer be held responsible for the assembly,
installation or start-up, nor any handling or fitting of components unless they are carried
out on its premises.
The salt electrolysis systems operate at 230VAC, 50/60 Hz. Do not attempt to alter the
system to operate at a different voltage.
Check that all the electrical connectors are well tightened to avoid false contacts and
their consequent overheating.
Before installing or replacing any component, disconnect the equipment from the mains,
and use exclusively spare parts supplied by the manufacturer.
Taking into account the fact that the equipment produces heat, it must be installed in
places with sufficient ventilation. Fan openings should be kept free of any element that
could obstruct them. The equipment should not be installed near flammable materials.
The salt electrolysis systems have an IP24 protection degree. They should never be
installed in places susceptible to flooding.
POWER SUPPLY:
DESCRIPTION
Standard working voltage
Output (dc)
Producción (g/h)
Pool volume (m
Warm: 16 – 24C
Hot: +25C
Flow detection
Salinity /Temperature range
Electrodes
Production control
Polarity switch
Salt level protection
(1)
Factory default.
(2)
Under ideal conditions: salinity (6 g/l), pH (7.2), water hardness (120 mg/l) and minimum flow rate.
SCG60 (MOD.12)
3
)
Estimated lifetime: 8.000 – 10.000 hours of operation (depending
Programmable: 2
MODEL
230 V AC, 50 Hz./60 Hz.
6 A x 2
10 - 12
60
50
Gas detector
5 ... 12 g./l. / +15 - 40
SELF-CLEANING coated Titanium
on water quality)
0 – 50 – 75 - 100 % ( 3 production levels)
(1)
/ 3 hours (jumper in control board) + test mode
Automatic protection of output current
2
SCG100 (MOD.21)
3.5 A x 6
17 - 21
100
80
o
C
(2)
Publicité
