Publicité
5.
OPERATION:_______________________________________________________________
5.1.
System on stand-by
The system goes into "STAND-BY" when the POWER SELECTOR" [2] key is successively
pressed until the "0%" light blinks. When this occurs, there is no production in the electrolysis cell.
5.2.
Production level selection
To select the desired production level, press the "POWER SELECTOR" [2] keys until the
production level light blinks. The system will set its production to the desired level after a few
seconds.
The production setpoint could be visualized at any time by pressing once the "POWER
SELECTOR" [2] key.
The light corresponding to the programmed production level will blink for a few seconds. After this
time the production scale will return to indicate the current production level.
Fig. 12
Fig. 13
11
Publicité
