Publicité
5.4.
Alarms
HIGH SALT LEVEL
If too much salt has been added, the power supply will reduce the level of power
with regard to that which was selected automatically. The "SALT" [3] led will stay
on. In this case, empty part of the swimming pool (for example 10%), and add fresh
water to reduce the salt concentration. To know the exact level of salt, we
recommend the use of a portable salinity-temperature meter.
LOW SALT LEVEL
If the level of salt in the swimming pools water were below the recommended level,
the power supply may not reach the level of output selected. The "SALT" [3] led will
blink. It is possible that the system indicates salt levels below the real ones if the
water temperature is less than 20
end of its lifetime. In this case, determine the level of salt in the water and add the
amount of salt needed The type of common salt (NaCl) indicated for salt
electrolysis should have no additives (anti-clogging agents, iodides) and should be
suitable for human consumption. To know the exact level of salt we recommend
the use of a portable salinity-temperature meter.
WATER LEVEL IN CELL/ FLOW DETECTOR (GAS)
If an air or gas bubble forms at any time at the top of the electrolysis cell and the
FLOW DETECTOR is not submerged, the system will automatically switch off
production and all of the leds of the control panel will blink. System automatically
resets when water flows through the cell again or the bubble disappear.
o
C or if the electrode package has reached the
Fig. 16
13
Publicité
