Publicité
A
Dipstick/Oil Fill
B
Fuel Tank and Cap
C
Starter Cord Handle
Drive Control Trigger
Located on the right side of the upper handle, the Drive Control Handle is used to engage and
disengage the drive wheels. Squeeze the Drive Control Handle against the upper handle to engage the
wheels; release to disengage.
Drive Speed Control Lever
The Speed Control is located on the center of the panel and is used to set the drive speed and direction
of travel. The speeds include forward and reverse.
Auger Control Trigger
Located on the left side of the upper handle, the Auger Control Handle is used to engage and
disengage the augers. Squeeze the Auger Control Handle to engage the augers; release to disengage
the augers.
Chute Rotation Handle
To adjust snow discharge direction, rotate the handle clockwise or counter-clockwise.... should
rotate 180 degrees.
Skid Shoe
Position the shoes based on the surface conditions. Adjust upward for hard-packed snow. Adjust
downward when operating on gravel or crushed rock surfaces.
Auger Blade and Impeller
When engaged, the auger blades rotate to cut snow and direct it into the auger/impeller housing to be
discharged out the chute.
Clean-out Tool
The chute Clean-out Tool is conveniently fastened to the rear of the auger housing with a mounting
clip. It is used to clean the chute assembly and chute opening when snow and ice become lodged.
WARNING! Never use your hands to clear a clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped before unclogging.
Wheel
13 inch snow tire
D
Throttle Control (if equipped)
E
Safety Key (if equipped)
F
Push Button Electric Start
G
Primer
8
Publicité
