Publicité
•
If the machine should start to vibrate abnormally, stop the engine, disconnect the spark plug wire and
ground it against the engine. Inspect thoroughly for damage. Repair any damage before starting and
operating.
•
Disengage all (drive and auger) control levers and stop engine before you leave the operation position
(behind the handles).
•
Wait until the auger /impeller comes to a complete stop before unclogging the chute assembly,
making any adjustments or inspections.
•
Never put your hand in the discharge or collector openings. Always use the clean-out tool provided to
unclog the discharge opening. Do not unclog chute assembly while engine is running. Shut off engine
and remain behind handles until all moving parts have stopped before unclogging.
•
Use only attachments and accessories approved by the manufacturer (e.g. wheel weights, tire chains,
cabs etc.).
•
When staring engine, pull cord slowly until resistance is felt, then pull rapidly, Rapid retraction of
starter cord (kickback) will pull hand and arm toward engine faster then you can let go. Broken bones,
fractures, bruises or sprains could result.
•
If situations occur which are not covered in this manual, use care and good judgment contact
customer support for assistance.
MAINTENANCE & STORAGE
•
Never tamper with safety devices. Check their proper operation regularly. Refer to the maintenance
and adjustment sections of manual.
•
Before cleaning, repairing, or inspecting machine disengage all control levers and stop the engine.
•
Wait until the auger impeller comes to a complete stop. Disconnect the spark plug wire to prevent
unintended starting.
•
Check bolts and screws for proper tightness (EVERYTIME before & after use) as engine vibration
could cause hardware to loosen.
This process will keep the machine in safe working condition. Also, visually inspect machine for any
damage.
•
Verify that the auger gearbox, located between your right and left auger blades, has substantial
lubricant in the casing.
The gearbox fill and drain plugs (bolts) are the only "vertical" plugs (bolts) on the gearbox assembly
when viewed in the standing position. The top plug (bolt) is used for filling...the bottom plug (bolt) is
for draining. Simply remove the top plug (bolt) for verification of lubricant, as it should be inside. To
drain, simply remove bottom plug (bolt).
•
Do not change the engine governor setting or over speed the engine. The governor controls the
maximum safe operating speed of the engine.
•
Snow thrower auger belts, shave plates, shear pins and skid shoes are subject to
wear and damage, therefore it is expected that the owner assume personal
responsibility for the maintenance (removal & installation) of these items.
•
For your safety protection, frequently check all components and replace with original equipment
manufacturers (OEM) parts only. Use of parts which do not meet the original equipment
specifications may lead to improper performance and compromise safety.
•
Check (drive & auger) control lever (handles) and cables periodically to verify they engage and
disengage properly and adjust, if necessary. Refer to the adjustment section in this operator's manual
for instructions.
•
Maintain or replace safety and instruction labels, as necessary.
•
Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
•
Prior to storing, run machine a few minutes to clear snow from machine and prevent freeze up of
auger impeller and completely wipe down unit, while inspecting for frozen components.
•
Never store the machine or fuel container inside where there is an open flame, spark or pilot light
such as water heater, furnace, clothes dryer etc.
•
Always refer to the operator's manual for proper instructions on off-season storage.
6
Publicité
