Publicité
Customer Quick Start Guide
Register Warranty
Make sure to register
your warranty at
canadianspacompany.com/
warranty
Power On
Follow start up instructions
on page 10 of this manual
Note: You must allow the spa to run
through its startup cycle before
adjusting any pump or heater
settings (5 to 10 minutes)
1-877-909-7727 |
CA:
QUICKSTART GUIDE
Electrical
Control Pack Here
We require you to hire a
licensed electrician to install
any electrical work needed to
operate your spa
Add Chemicals
SCAN
below to try
our Spa Water Test
App
Follow our Spa
Chemical Startup Guide
instructions to balance
your water
1-844-879-7727
US:
Fill Hot Tub
Remove filter cover and
insert hose in opening to
fill the spa through the
filter housing
Wait for Water to Heat
The water will take
4-6 hours for 240V to
reach full temperature
FOR MORE HELP GUIDES VISIT US AT:
CANADIAN SPA CO.
support.canadianspacompany.com
1-877-909-7727
3
Insert Filters
Fill water to half
way up the filter
housing
Once the hot tub is filled,
install your new Glacier
Antimicrobial Filter Set. Make
sure not to over tighten
Note: Spa is filled when water is
touching the LED perimeter lighting.
Sit back and relax in
your brand new spa!
Enjoy
Publicité
