Publicité
STEP 8
OUTSIDE SUPPORT MOUNTING – Assemble the support
brackets (Item #1) to the bottom rails of the cab i net with four
(4) 10-24 1" long screws (Item #2) and four (4) 10-24 fl at nuts
(Item #3). Adjust the support brackets to bring the bottom pads
in contact with the wall surface. (A 1" x 4" or 2" x 4" SPACER
SHOULD BE USED BETWEEN THE WALL AND THE
SUPPORT BRACKETS WHEN IN STALLED ON ALU MI NUM
OR VINYL SIDING). Drill
brack ets to the wall with two (2) #12A x 2" long screws (Item
#4). Adjust the support brackets to provide an ap prox i mate 3/8"
down slope toward the out side for drainage. (See Figure D).
Tighten all screws.
NOTE: The discharge air, return air, condenser air inlets and
outlets must be unobstructed to avoid recirculation of rejected
heated air.
The following illustrations show a standard frame con struc tion installation as well as some suggested ways of adapt ing the support bracket to thick walls and
large stone ledges.
Figure D
1" x 4" OR 2" x 4" SPACER SHOULD BE USED
BE TWEEN WALL AND BRACKET WHEN IN STALLED
ON ALUMINUM, ASBESTOS OR VINYL SIDING
Figure E
NOTE: It is not necessary to cut the wingboard for
vertical height; only horizontal WIDTH Dimension "B".
⁄
" dia. pilot holes and secure the
5
32
⅜" DOWN SLOPE
SUPPORT BRACK ET
(ITEM #1)
#12A x 2" SCREW
(ITEM #4)
920-198-00
Figure C
CENTER
CABINET IN
WINDOW SIDE
TO SIDE.
DRILL (3)
5
⁄
"
32
PILOT HOLES
AND INSTALL
(3) #12A x
2" LONG
SCREWS
(ITEM #4)
WINDOW
SILL
MEASURE DISTANCE "B" TO INSIDE OF THE
CHANNEL ON EACH SIDE
CUT HERE AND DISCARD CENTER WASTE
MATERIAL.
WINGBOARD
SUBTRACT ⅛" FROM DIMENSION "B" AND
MEA SURE FROM THE EDGE OF THE WING-
BOARD (ITEM # 8), MARK, SCORE AND CUT
WITH APPROPPRIATE CUTTING TOOL
LOCATE SILL PLATE GUIDE CHAN NEL
JUST BACK OF WIN DOW SILL
SUPPORT
BRACKET
10 – 24 FLAT WELD
NUT (ITEM #3)
10 – 24 x 1" HEX HD.
SCREW (ITEM #2)
TOP
SUPPORT
ANGLE
PULL
WINDOW
SASH DOWN
BEHIND TOP
SUPPORT
ANGLE
SIDE
SUPPORT
ANGLE
11
Publicité
