Publicité
OPERATING YOUR WASHER
Understanding what happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation occurs with
the washer lid up or down.
During agitation, the XTRA ROLL ACTION*
WASH
Wash selected time
No agitation
The Permanent Press cycle partially
†
drains, fills, agitates briefly, and drains.
MAGIC CLEAN * lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
10
All manuals and user guides at all-guides.com
agitator creates
a continuous
rollover action
that provides a
thorough cleaning
of the wash load.
Fill
Drain
†
Spin
After agitation starts, the Cycle Control Knob
turns clockwise until it points to an OFF area
and the cycle ends.
NOTES:
•
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
•
A Gentle Wash system helps protect your
fabrics by reducing wash agitation speed
during the last few minutes of wash
agitation in the Normal and Permanent
Press cycles.
RINSE
Drain-No agitation
Spin-Spray rinse
Basket
MAGIC CLEAN
interior
lint filter
Fill
Rinse
Spin
Off
Publicité
