Publicité
ENGLISH
Water Container
The water removed from the laundry
during the drying cycle is collected in a
container at the bottom of the dryer.
We recommend that the container is
emptied after each drying cycle.
To remove the container:
1. Gently pull the bottom of the kickplate
so that it unclips from the dryer (fig. 5).
The top section can then be unhinged
allowing the kickplate to be completely
removed.
2. Pull firmly on the handgrip and slide
the water container out of the dryer
(fig. 6). Support the container with both
hands. When full, the water container
will weigh about 4 kg (fig. 7).
3. Open the lid located on the top of the
container and empty the water (fig. 8).
4. Refit the lid and slide the water
container back into position. PUSH
FIRMLY INTO PLACE.
5. Refit the kickplate by engaging the
hinges at the top and 'snapping' the
lower clips into place.
8
Condenser
IMPORTANT: Always switch off and
remove the plug from the electricity
supply before cleaning the condenser.
To maintain the efficiency of the dryer
regularly check that the condenser is
clean.
To remove the condenser:
1. Remove the kickplate (fig. 5).
2. Turn the two locking levers anti-
clockwise (fig. 9).
3. Pull out the condenser unit (fig. 10).
4. Gently remove any dust or fluff with a
cloth, then wash the unit by holding it
under a running tap (fig. 11) turning it
so that water flows between the plates,
to remove any dust or fluff.
5. Refit the condenser ensuring it is
pushed firmly into place. Lock the two
levers by turning them clockwise.
6. Refit the kickplate.
Publicité
