Publicité
8.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
WARNING
Always remove the battery pack after you complete
the work.
8.3
OPERATE THE SELF-PROPEL
SYSTEM
NOTE
The machine is built with a thermal protector to stop
the self-propelled motor when overload occurs. It's a
device calibrated to open the self-propelled motor
circuit upon reaching a certain temperature/current.
Re-setting the protector requires both cool down
below the calibration point and removal of power
supply. When the protection happens, the operator
should release the self-propel bail lever (5)
immediately ,then restart self-propel operation after at
least 30 minutes.
1. Start the machine.
2. While you hold the bail switch (4), push the self-
propel lever (5) in the direction of the handle bar.
3. Hold the bail switch (4) and the self-propel lever (5)
at the same time with your right hand.
4. Adjust the speed control button (6) with your left
hand.
•
Push the speed control button in the direction of
the Rabbit Symbol to increase the speed.
•
Pull the speed control button in the direction of
the Turtle Symbol to decrease the speed.
5. Release the self-propel lever (5) to close the self-
propel system.
8.4
EMPTY THE GRASS CATCHER
1. Stop the machine.
English
2. Remove the battery pack.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and unhook it
from the door rod.
5. Close the rear discharge door.
6. Empty the grass catcher.
8.5
OPERATE ON SLOPES
Do not mow on the slopes with incline more than 15°.
If you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you
mow on a slope.
•
Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
•
Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
•
Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
•
Do not mow near drop-offs, ditches, or
embankments.
8.6
OPERATION TIPS
•
Do not try to override the operation of the start
button or bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning
parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick
grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
9
MAINTENANCE
Remove the safety key and battery pack from the
machine before maintenance.
Keep the motor and battery pack free from grass,
leaves or too much grease.
11
WARNING
WARNING
WARNING
WARNING
EN
Publicité
