Installation Instructions; Tools You Will Need; Preparing The Enclosure; Electrical Requirements - Silhouette DBC031D1BSSPR Manuel Du Propriétaire

Installation Instructions - Intergrated Application

Tools You Will Need

Safety goggles
Electric drill with hole bit
Gloves
Preparing the
Enclosure

Electrical Requirements:

The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
Fig E
NOTE:
This unit is front breathing.
Do not block the front air vent.
Blockage of the vent will result
in high operating temperatures
and system failure. (Fig.E)
*The listed depth requirement for the
installation is assuming that the electrical
outlet is located in the adjacent cabinetry
or is flush mounted in the rear wall, not
surface mounted in the enclosure.
Tape measure
Flashlight
Level
It is recommended that you do
not install the beverage cooler
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
The rough cabinet opening
must be on a level floor area
and at least 23 1/16" deep
(63.2cm) by 15 1/16"(38.6cm)
wide. The opening should also
have a height of at least
34 9/16 "(86.8 cm).
Fig F
Cabinet is
square
and plumb
8
FOR YOUR
SAFETY
Carpenter square
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry , or
the rear of the shaded area (as
shown in Fig F).
Important: If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirement for the installation
may be affected.
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2"(3.81cm) diameter hole to
admit the power cord. If the cabi-
net wall is metal, the hole edge
must be covered with a bushing
or grommet.
23
1
/16"
min
1
1
/ " dia hole
2
*If electrical outlet
is in adjacent cabinetry
15 / "
1
16
1 /
3
Electrical Access
6"
While performing
installations
described in this
section, gloves,
safety glasses or
goggles should
be worn.
"
/
9
34
16
From underside
" of countertop
16
to floor