Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Intergrated Application
Tools You Will
Need
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves and
safety glasses or goggles
should be worn.
Preparing the
Enclosure
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, by a 15 or 20 ampere
circuit breaker or time
delay fuse.
• It is recommended that you do
not install the wine cooler into a
corner (i.e. directly beside a
wall). This is to allow the door(s)
to have a greater than 90° open-
ing swing. A limited door swing
will prevent the shelves from
sliding out as intended, and may
lead to damaging the door gas-
ket(s).
• The rough cabinet opening
must be on a level floor area
and at least 26 " deep* by 24"
wide. The opening should also
have a height of at least 34-7 /16 ".
Fig C
1-1/2" dia. hole
*if electical outlet
is in adjacent
cabinetry
34-3/4"
From
Underside of
Countertop to
Floor
Electrical Access
24"
8
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig C.).
Important: If the electrical out-
let is surface mounted (not flush)
within the enclosure, the depth
requirment for the installation
will be affected.
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2" diameter hole to admit
the power cord. If the cabinet wall
is metal, the hole edge must be covered
with a bushing or grommet.
26"
Min*
2"
Cabinets
Square
and
Plumb
6"
Publicité
Chapitres
Table des Matières
